crwdns2933423:0crwdne2933423:0

三星盖乐世S3前面玻璃更换

crwdns2931527:0crwdnd2931527:0crwdnd2931527:0crwdnd2931527:0crwdne2931527:0

crwdns2936315:0crwdne2936315:0
crwdns2936311:0crwdne2936311:0
crwdns2931653:012crwdne2931653:0
Samsung Galaxy S III Broken Front Glass Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:01crwdne2935265:0
  • Clean up the glue that remains on the borders. A small microfiber with a bit of WD40 or windex can help you take all the glue off.

  • Be sure to not use too much WD40 or windex.

  • When cleaning out the glue, do NOT attempt to scrape glue out of the cracks between the LCD and the frame. A very small amount of force toward the center or from underneath will crack the LED.

  • Cut up two small 1mm pieces of the sticker tape and glue the buttons to the phone to keep them in place.

  • It's very important to make sure the buttons line up exactly with the picture.

清理残留在边界上的胶水。有一点WD40或该小微纤维可以帮助你把所有的胶水清理掉。

不要使用太多的WD40或清洗剂。

清洗胶水时,不要试图将胶水从LCD和框架之间的缝隙中取出。一个向中心或下方的非常小的力将使LED产生裂纹。

剪下两块1毫米宽的胶带,然后将按键粘在手机上,使它们保持在适当的位置。

确保按钮和图片完全一致是很重要的。

[* black] Clean up the glue that remains on the borders. A small microfiber with a bit of WD40 or windex can help you take all the glue off.
[* icon_note] Be sure to not use too much WD40 or windex.
- [* icon_caution] When cleaning out the glue, do NOT attempt to scrap glue out of the cracks between the LCD and the frame. A very small amount of force toward the center or from underneath will crack the LED.
+ [* icon_caution] When cleaning out the glue, do NOT attempt to scrape glue out of the cracks between the LCD and the frame. A very small amount of force toward the center or from underneath will crack the LED.
[* black] Cut up two small 1mm pieces of the sticker tape and glue the buttons to the phone to keep them in place.
[* icon_note] It's very important to make sure the buttons line up exactly with the picture.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0