crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

CR-10 X Linear Rail Replacement

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:03crwdnd2931529:0crwdne2931529:0

crwdns2935421:0crwdne2935421:0

crwdns2935425:05crwdne2935425:0

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936323:0crwdne2936323:0
crwdns2931653:05crwdne2931653:0
CR-10 X Linear Rail Replacement, X Carriage install: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 CR-10 X Linear Rail Replacement, X Carriage install: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 CR-10 X Linear Rail Replacement, X Carriage install: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
X Carriage install

  • Belt adaptor

  • 4x M3x8 SHCS

  • 3x M3 split washers

  • M3 Hex nuts

  • Install the M3x8 SHCS screw with M3 Split washer in to the X carriage adaptor plate and mount to the Rail block.

  • Push up on the belt bracket, it is square against the bottom of the carriage block.

  • Note: If screws will not start, threading in. Spin the screws counterclockwise until you hear a click, and then tighten the screws evenly in an X pattern until they are fully tightened. This is to ensure that the threads do not get damaged.

  • Note, reference Hotend Mounting Instructions section before mounting the MGN 12 Adaptor Plates to the linear rail block. For installing Hex Nuts to the back of the Adaptors.

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0