crwdns2933423:0crwdne2933423:0

Sostituzione pannello in vetro posteriore Xiaomi Mi 11 Lite

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:03crwdnd2931529:0crwdne2931529:0

crwdns2936315:0crwdne2936315:0
crwdns2936321:0crwdne2936321:0
crwdns2931653:02crwdne2931653:0
Xiaomi Mi 11 Lite Rear Glass Panel Replacement, Create a gap: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Xiaomi Mi 11 Lite Rear Glass Panel Replacement, Create a gap: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Xiaomi Mi 11 Lite Rear Glass Panel Replacement, Create a gap: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Create a gap
  • Secure a suction handle to the right edge of the rear glass, as close to the edge as possible.

  • If the rear glass is cracked, the suction handle may not stick. Try lifting it with strong tape, or superglue the suction handle in place and allow it to cure so you can proceed.

  • Lift the rear glass with the suction handle to create a small gap between the rear glass and the frame.

  • If you have trouble creating a gap, apply more heat to further soften the adhesive. Follow the iOpener instructions to avoid overheating.

  • Insert an opening pick into the gap you created.

  • Slide the opening pick to the top right corner to slice the adhesive.

  • Leave the opening pick in place to prevent the adhesive from resealing.

Fissa un manico a ventosa al bordo destro del vetro posteriore, il più vicino possibile al bordo.

Se il vetro posteriore è spaccato, il manico a ventosa potrebbe non attaccarsi. Prova a sollevarlo con un nastro adesivo forte, o incolla il manico a ventosa in posizione con della supercolla e fallo asciugare così puoi procedere.

Solleva il vetro posteriore con il manico a ventosa per creare una piccola fessura tra il vetro posteriore e il telaio.

Se non riesci a creare una fessura, applica più calore per ammorbidire meglio l'adesivo. Segui le istruzioni dell'iOpener per evitare di riscaldarlo troppo.

Inserisci un plettro di apertura nella fessura da te creata.

Fai scivolare il plettro di apertura verso l'angolo superiore destro per tagliare l'adesivo.

Lascia il plettro di apertura in posizione per prevenire che l'adesivo si riattacchi.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0