crwdns2933423:0crwdne2933423:0

Hoe een continuïteitstester te bouwen van alledaagse voorwerpen

crwdns2936315:0crwdne2936315:0
crwdns2936313:0crwdne2936313:0
crwdns2931653:04crwdne2931653:0
How to build a continuity tester from common everyday items, Construction: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 How to build a continuity tester from common everyday items, Construction: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 How to build a continuity tester from common everyday items, Construction: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Construction
  • Wrap one wire around the bend contact a couple of times and twist the end around the wire itself.

  • Place the exposed wire from the other cable on the flat contact on the circuit board.

  • Use electric tape to secure the bottom wire and to isolate and secure the wire on the other contact as well.

  • The components are adhered via some kind of tape to the card. This tape functioned as a guide to cut the whole musical part way from the greeting card.

Wikkel een draad een aantal keer om het gebogen contact heen en draai het uiteinde van het contact ook om de draad heen.

Leg de blootliggende draad van de andere kabel op het platte contact op de printplaat.

Gebruik isolatietape om de onderste draad vast te zetten en om de draad op het andere contact ook te isoleren en vast te zetten.

De componenten zijn met tape op een kaart geplakt. Deze tape helpt bij het wegsnijden van het hele muzikale gedeelte omdat je op die manier weet waar de onderdelen beginnen en eindigen.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0