crwdns2933423:0crwdne2933423:0

Sustitución del puerto de carga USB de los auriculares bluetooth SONY WH-CH700N

crwdns2935425:08crwdne2935425:0

crwdns2936315:0crwdne2936315:0
crwdns2936331:0crwdne2936331:0
crwdns2931653:08crwdne2931653:0
SONY WH-CH700N bluetooth headphones USB charging port Replacement, Desolder the USB connector: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 SONY WH-CH700N bluetooth headphones USB charging port Replacement, Desolder the USB connector: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
Desolder the USB connector
  • Grab the connector with tweezers and apply heat from the mounting pins' side (bottom).

  • Be careful with the hot air station and position the board in a way that you do not burn the jack connector while heating up the port.

  • 320 degrees (Celsius) with 20-30% airflow is more than enough to get the connector off.

  • Clean the pads with a solder wick.

Toma el conector con pinzas y aplica calor desde el lado de los pines de montaje (inferior).

Ten cuidado con la estación de aire caliente y coloca la placa de manera que no se queme el conector jack mientras calientas el puerto.

320 grados (Celsius) con un 20-30% de flujo de aire es más que suficiente para desconectar el conector.

Limpia las almohadillas con una mecha de soldadura.

[title] Desolder the USB connector
-[* black] Grab the connector with tweezers and apply heat from the mounting pins' side (bottom).
+[* black] Grab the connector with [product|IF145-020|tweezers] and apply heat from the mounting pins' side (bottom).
[* icon_caution] Be careful with the hot air station and position the board in a way that you do not burn the jack connector while heating up the port.
[* icon_note] 320 degrees (Celsius) with 20-30% airflow is more than enough to get the connector off.
[* black] Clean the pads with a solder wick.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0