crwdns2933423:0crwdne2933423:0

Microsoft Surface Pro 5のマザーボード交換

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:02crwdnd2931529:0crwdne2931529:0

crwdns2936315:0crwdne2936315:0
crwdns2936323:0crwdne2936323:0
crwdns2931653:011crwdne2931653:0
Microsoft Surface Pro 5 Motherboard Assembly Replacement, Remove the microSD card reader connector shield: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Microsoft Surface Pro 5 Motherboard Assembly Replacement, Remove the microSD card reader connector shield: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Microsoft Surface Pro 5 Motherboard Assembly Replacement, Remove the microSD card reader connector shield: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Remove the microSD card reader connector shield
  • Insert one point of a pair of pointed tweezers into a gap in the corner of the EMI shield covering the microSD card reader connector.

  • Use the tweezers to pry the EMI shield away from the motherboard as much as you can without bending it.

  • Repeat this procedure at different points around the shield until it is free. Remove the shield.

  • Try not to deform the shield too much—you will need to reinstall it during reassembly.

  • Take care not to puncture the battery with the tweezers while working on this shield.

先の尖ったピンセットの片方の先を、microSDカードリーダー接続コネクタを覆っている電磁シールドの角の1つの隙間に差し込みます。

ピンセットを使って電磁シールドをマザーボードから剥がしていきますが、電磁シールドを曲げないでできるところまでにして下さい。

上記の作業をシールドの他の角に対しても繰り返して、マザーボードから完全に剥がして下さい。剥がれたらシールドを取り除きます。

シールドを曲げすぎないように注意して下さい。組み立て直す際に貼り直す必要があります。

シールドを剥がす作業中にバッテリーに穴を開けないように注意して下さい。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0