crwdns2933423:0crwdne2933423:0

Jura Impressa S Model Water Boiler repair/replacment

crwdns2935425:06crwdne2935425:0

crwdns2936319:0crwdne2936319:0
crwdns2936315:0crwdne2936315:0
crwdns2931653:06crwdne2931653:0
Jura Impressa S Modelle Dampfventil revidieren/tauschen: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Jura Impressa S Modelle Dampfventil revidieren/tauschen: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Jura Impressa S Modelle Dampfventil revidieren/tauschen: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
  • Drehe das Ventiloberteil um. Die Formdichtung wird sichtbar. Achte auf ihren Sitz, so muss sie später wieder im Ventilunterteil sitzen, sonst funktioniert das Ventil nicht.

  • Hebe sehr vorsichtig die Formdichtung und die beiden Keramikscheiben heraus. Merke dir genau die Einbaulage.

  • Nun kannst du alle Teile reinigen. Wenn die Dichtung defekt ist, musst du sie ersetzen.

  • Achte beim Zusammenbau genau auf die korrekte Orientierung.

Turn the valve bonnet over. The molded seal becomes visible. Make sure that it is seated correctly; it must be seated in the valve body again later, otherwise the valve will not work.

Carefully lift out the molded seal and the two ceramic washers. Note the exact installation position.

Now you can clean all parts. If the seal is defective, you need to replace it.

Pay close attention to the correct orientation when assembling.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0