crwdns2933423:0crwdne2933423:0

Poco X3 Pro Akku tauschen

crwdns2931527:0crwdnd2931527:0crwdnd2931527:0crwdnd2931527:0crwdne2931527:0

crwdns2935425:04crwdne2935425:0

crwdns2936315:0crwdne2936315:0
crwdns2936319:0crwdne2936319:0
crwdns2931653:04crwdne2931653:0
Poco X3 Pro Battery Replacement, Remove the battery: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Poco X3 Pro Battery Replacement, Remove the battery: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Poco X3 Pro Battery Replacement, Remove the battery: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Remove the battery
  • Grab both pull–tab ends labelled with an A and pull up on the orange adhesive strip to lift the battery out of its recess and swing it up to an upright position.

  • Although these adhesive tabs are supposed to make the battery removal easier, they may require some force. In case you're having trouble removing the battery, you can apply a heated iOpener to the center of the display to loosen the adhesive underneath.

  • Peel the battery off the remaining adhesive.

  • Remove the battery.

  • During reassembly, temporarily reconnect the battery to the motherboard to help align it correctly. Disconnect the battery after it is seated.

  • In case you're replacing the adhesive sticker with a new one, peel the battery's adhesive sticker off the midframe and clean the relevant areas with isopropyl alcohol (>90%). Let the alcohol dry before installing new adhesive.

Fasse die beiden mit A markierten Enden des orangenen Klebestreifens an und kippe den Akku aus seiner Vertiefung heraus bis er senkrecht steht.

Die Zuglaschen sind zwar dafür gedacht, den Ausbau des Akkus zu erleichtern, es kann aber trotzdem recht schwer gehen. In diesem Fall kannst du einen erwärmten iOpener in der Mitte des Displays auflegen, um den Kleber darunter aufzuweichen.

Löse den Akku vom restlichen Kleber ab.

Entferne den Akku.

Schließe den Akku beim Zusammenbau zeitweise wieder an die Hauptplatine an, damit er seine richtige Einbaulage findet. Trenne ihn dann wieder ab.

Wenn du die Klebestreifen erneuern willst, dann ziehe den Akkuklebestreifen vom Mittelrahmen ab und reinige die Klebestellen mit Isopropylalkohol (mindestens 90%ig). Lasse den Alkohol wegtrocknen, bevor du neue Klebestreifen anbringst.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0