crwdns2933423:0crwdne2933423:0

Sostituzione pannello posteriore Poco X3 Pro

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:03crwdnd2931529:0crwdne2931529:0

crwdns2936315:0crwdne2936315:0
crwdns2936321:0crwdne2936321:0
crwdns2931653:02crwdne2931653:0
Poco X3 Pro Back Cover Replacement, Insert an opening pick: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Poco X3 Pro Back Cover Replacement, Insert an opening pick: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Poco X3 Pro Back Cover Replacement, Insert an opening pick: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Insert an opening pick
  • Secure a suction handle to the bottom edge of the back cover, as close to the edge as possible.

  • If the back cover is cracked, the suction handle may not stick. Try lifting it with strong tape, or superglue the suction handle in place and allow it to cure so you can proceed.

  • Lift the back cover with the suction handle to create a small gap between the back cover and the frame.

  • In case you have trouble creating a gap, apply more heat to further soften the adhesive. Follow the iOpener instructions to avoid overheating.

  • Insert an opening pick into the gap you created.

  • Slide the opening pick to the bottom right corner to slice the adhesive.

  • Leave the opening pick in place to prevent the adhesive from resealing.

Fissa una ventosa al bordo inferiore della cover posteriore, il più vicino possibile al bordo.

Se la cover posteriore è rotta, la ventosa potrebbe non aderire. Prova a sollevarlo con del nastro adesivo forte o incolla la ventosa in posizione e lascia che si asciughi in modo da poter procedere.

Solleva la cover posteriore con la ventosa per creare un piccolo spazio tra la cover posteriore e il telaio.

Se hai problemi a creare una fessura, applica più calore per ammorbidire ulteriormente l'adesivo. Segui le istruzioni dell'iOpener per evitare il surriscaldamento.

Inserisci un plettro di apertura nella fessura che hai creato.

Fai scorrere il plettro di apertura nell'angolo in basso a destra per tagliare l'adesivo.

Lascia il plettro di apertura in posizione per evitare che l'adesivo si rincolli.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0