crwdns2933423:0crwdne2933423:0

Reemplazo de la carcasa trasera del Poco X3 Pro

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:03crwdnd2931529:0crwdne2931529:0

crwdns2936315:0crwdne2936315:0
crwdns2936331:0crwdne2936331:0
crwdns2931653:02crwdne2931653:0
Poco X3 Pro Back Cover Replacement, Insert an opening pick: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Poco X3 Pro Back Cover Replacement, Insert an opening pick: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Poco X3 Pro Back Cover Replacement, Insert an opening pick: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Insert an opening pick
  • Secure a suction handle to the bottom edge of the back cover, as close to the edge as possible.

  • If the back cover is cracked, the suction handle may not stick. Try lifting it with strong tape, or superglue the suction handle in place and allow it to cure so you can proceed.

  • Lift the back cover with the suction handle to create a small gap between the back cover and the frame.

  • In case you have trouble creating a gap, apply more heat to further soften the adhesive. Follow the iOpener instructions to avoid overheating.

  • Insert an opening pick into the gap you created.

  • Slide the opening pick to the bottom right corner to slice the adhesive.

  • Leave the opening pick in place to prevent the adhesive from resealing.

Fija una ventosa en el borde inferior de la tapa trasera, lo más cerca posible del borde.

Si la tapa trasera está agrietada, es posible que la ventosa no se adhiera. Trata de levantarlo con cinta resistente o super pegamento el mango de succión en su lugar y deja que se seque para que pueda continuar.

Levanta la tapa trasera con la ventosa para crear un pequeño espacio entre la tapa trasera y el marco.

En caso de que tengas problemas para crear un espacio, aplica más calor para ablandar aún más el adhesivo. Sigaue las instrucciones de iOpener para evitar el sobrecalentamiento.

Inserta una púa de apertura en el espacio que creaste.

Desliza la púa de apertura hacia la esquina inferior derecha para cortar el adhesivo.

Deja la púa de apertura en su lugar para evitar que el adhesivo se vuelva a sellar.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0