crwdns2933423:0crwdne2933423:0

Bosch PBD40 bench drill press circuit board speed control Replacement

crwdns2935425:03crwdne2935425:0

crwdns2936319:0crwdne2936319:0
crwdns2936315:0crwdne2936315:0
crwdns2931653:03crwdne2931653:0
Bosch PBD40 Ständerbohrmaschine Leiterplatte Drehzahlregelung Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Bosch PBD40 Ständerbohrmaschine Leiterplatte Drehzahlregelung Replacement: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Bosch PBD40 Ständerbohrmaschine Leiterplatte Drehzahlregelung Replacement: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
  • Auf der rechten Seite ist auch noch ein Adapter vom Getriebeschalter zum Getriebe. Dieser ist nur aufgesteckt und beim Zusammenbau kniffelig.

  • Jetzt könnte man auch die Kohlebürsten (grüner Pfeil) tauschen. Der rote Pfeil zeigt den Höhenmesser

  • Von unten am Bohrkopf vorbei ist der runde Magnet und die Sensorplatine für die Drehzahlmessung zu sehen. Die Drehzahl wird übrigens nur angezeigt, hat aber keine Regelfunktion. Das macht nur der Drehzahlregler ganz analog.

On the right side there is also an adapter from the transmission switch to the transmission. This is only plugged on and tricky to assemble.

Now you could also change the carbon brushes (green arrow). The red arrow shows the measuring bar

From below the drill head, you can see the round magnet and the sensor board for the RPM measurement. By the way, the speed is only displayed, but has no control function. This is only done by the speed controller in analog mode.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0