crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

小米11背板玻璃更换

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:03crwdnd2931529:0crwdne2931529:0

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936311:0crwdne2936311:0
crwdns2931653:02crwdne2931653:0
Mi 11 Rear Glass Replacement, Insert an opening pick: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Mi 11 Rear Glass Replacement, Insert an opening pick: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Mi 11 Rear Glass Replacement, Insert an opening pick: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Insert an opening pick

  • Secure a suction handle to the bottom edge of the rear glass, as close to the edge as possible.

  • If the rear glass is cracked, the suction handle may not stick. Try lifting it with strong tape, or superglue the suction handle in place and allow it to cure so you can proceed.

  • Lift the back cover with the suction handle to create a small gap between the back cover and the frame.

  • In case you have trouble creating a gap, apply more heat to further soften the adhesive. Follow the iOpener instructions to avoid overheating.

  • Insert an opening pick into the gap you created.

  • Slide the opening pick to the bottom right corner to slice the adhesive.

  • Leave the opening pick in place to prevent the adhesive from resealing.

插入撬片

将吸盘手柄固定在后玻璃的底部边缘，尽可能靠近边缘

如果玻璃背板破裂，吸盘可能卡不住。尝试用强力胶带提起，或将吸盘手柄用强力胶水固定到位并使其固化，以便您可以继续

用吸盘提起后盖，在后盖和框架之间留出一个小间隙

如果您在形成间隙时遇到困难，请加热以进一步软化中框内的胶。按照 iOpener说明作以避免过热（译者注：用热吹风机吹就行，哪拉不起来哪多吹会）

将翘片插入您创建的间隙中

将撬片滑到右下角以割断中框胶

将翘片留在原位，以防止中框胶重新密封

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0