crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

Reemplazo de los pies del mouse principal Logitech G903

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:03crwdnd2931529:0crwdne2931529:0

crwdns2935423:0crwdne2935423:0

crwdns2935425:01crwdne2935425:0

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936331:0crwdne2936331:0
crwdns2931653:01crwdne2931653:0
Logitech G903 Main Mouse Feet Replacement, Heat the mouse foot: crwdns2935265:00crwdnd2935265:01crwdnd2935265:01crwdne2935265:0
Heat the mouse foot

  • The feet are secured to the bottom of the mouse with strong adhesive. In order to cleanly remove them, the adhesive needs to be thoroughly heated.

  • Heat an iOpener and lay it on the mouse feet for one minute to heat the adhesive.

  • Alternatively, you can use a hair dryer on the Low heat setting to soften the adhesive.

  • If you're using a hair dryer, only heat the feet a few seconds at a time or you may warp the plastic shell.

Calentar el pie del ratón

Si planeas reutilizar los pies de mouse existentes, ten en cuenta que el adhesivo debe calentarse completamente para quitarlos limpiamente.

Calienta un iOpener y aplícalo al pie inferior del mouse durante dos minutos.

También se puede utilizar un secador de pelo o una pistola de aire caliente, pero ten cuidado de no sobrecalentar el ratón, ya que la batería interna es susceptible de sufrir daños por calor.

[title] Heat the mouse foot
-[* icon_note] If you’re planning to reuse your existing mouse feet, note that the adhesive needs to be thoroughly heated to cleanly remove them.
-[* black] [guide|25705|Heat an iOpener|new_window=true] and apply it to the bottom mouse foot for two minutes.
- [* icon_note] A hair dryer or heat gun may also be used, but be careful not to overheat the mouse—the internal battery is susceptible to heat damage.
+[* icon_note] The feet are secured to the bottom of the mouse with strong adhesive. In order to cleanly remove them, the adhesive needs to be thoroughly heated.
+[* black] [guide|25705|Heat an iOpener|new_window=true] and lay it on the mouse feet for one minute to heat the adhesive.
+ [* icon_note] Alternatively, you can [guide|157348|use a hair dryer|new_window=true] on the ***Low*** heat setting to soften the adhesive.
+ [* icon_caution] If you're using a hair dryer, ***only heat the feet a few seconds at a time*** or you may warp the plastic shell.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0