crwdns2933423:0crwdne2933423:0

拆开机身

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:019crwdnd2931529:0crwdne2931529:0

crwdns2936315:0crwdne2936315:0
crwdns2936311:0crwdne2936311:0
crwdns2931653:010crwdne2931653:0
Opening Procedure: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Opening Procedure: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Opening Procedure: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
  • Insert a new opening pick into the bottom left corner and slide it around the corner toward the left edge.

  • Be careful cutting under the lower 2.5 inches (65 mm) of the left edge. Don't insert the opening pick more than 1/8 inch (3 mm) here. The display cables sit near this part of the bezel and are easily damaged.

  • Once past the display cable area, you can insert the pick to 0.45 in (12 mm) again.

  • Slide the pick along the left edge of the Surface to cut through the screen adhesive.

  • Leave this pick in the left edge to prevent the adhesive from resealing.

将新的三角撬片插入左下角,然后将其围绕拐角向左边缘滑动。

小心在左边缘下方 2.5 英寸(65 毫米)下切割。不要在此处插入三角撬片超过 1/8 英寸(3 毫米)。显示器电缆位于挡板的这一部分附近,很容易损坏。

穿过显示电缆区域后,你可以再次将撬片插​​入 0.45 英寸(12 毫米)。

沿着 Surface 的左边缘滑动撬片以切开屏幕粘合剂。

将此三角撬片留在左边缘以防止粘合剂重新密封。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0