crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

9.7寸iPad Pro上扬声器更换

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:05crwdnd2931529:0crwdne2931529:0

crwdns2935421:0crwdne2935421:0

crwdns2935425:06crwdne2935425:0

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936311:0crwdne2936311:0
crwdns2931653:06crwdne2931653:0
iPad Pro 9.7" Upper Speaker Replacement, Remove the upper speaker: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 iPad Pro 9.7" Upper Speaker Replacement, Remove the upper speaker: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
Remove the upper speaker

  • Lift and remove the upper speaker from the frame.

  • There are multiple cables under the upper speaker. Be careful not to damage them while removing it.

  • If any cables are still attached to the upper speaker while you lift it up, carefully peel them off of the upper speaker. You can apply more isopropyl alcohol if they don't easily peel away.

  • If the ZIF connector sticker near the front camera comes off while removing the upper speaker, reapply it to the ZIF connector.

  • If the ZIF connector near the front camera disconnects while removing the upper speaker, use the pointed end of a spudger to flip up the locking flap. Then, reinsert the ribbon cable and close the locking flap.

  • During reassembly, make sure the right ambient light sensor is on top of its shelf.

  • If there's any alcohol solution remaining in the device, carefully wipe it off or allow it to air dry before reinstalling the upper speaker.

取下上扬声器

将上扬声器从框架中取出。

上扬声器下面有多根排线。在取下时要小心不要损坏它们。

如果在抬起上扬声器时仍然有任何排线连接到上扬声器上，请小心地将它们从上扬声器上剥离。如果它们不容易剥离，可以再次涂抹更多的异丙醇。

如果在取下上扬声器时，靠近前置摄像头的ZIF接口贴纸脱落，请将其重新贴到ZIF接口上。

如果在取下上扬声器时，靠近前置摄像头的ZIF接口断开，请使用撬棒的尖端翻起锁定夹。然后重新插入扁平电缆并关闭锁定夹。

在重新组装过程中，请确保右侧环境光传感器位于其支架的顶部。

如果设备中仍有任何酒精溶液，务必小心擦拭干净或在重新安装上扬声器之前让其自然风干。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0