crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

Microsoft Surface Pro 6 SurfaceConnect- Anschluss tauschen

crwdns2935423:0crwdne2935423:0

crwdns2935425:01crwdne2935425:0

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936319:0crwdne2936319:0
crwdns2931653:01crwdne2931653:0
Microsoft Surface Pro 6 SurfaceConnect Port Replacement, Disconnect the microSD card reader: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Microsoft Surface Pro 6 SurfaceConnect Port Replacement, Disconnect the microSD card reader: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Microsoft Surface Pro 6 SurfaceConnect Port Replacement, Disconnect the microSD card reader: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Disconnect the microSD card reader

  • Insert one point of a pair of pointed tweezers into a gap in the corner of the EMI shield covering the microSD card reader connector.

  • Use the tweezers to pry the EMI shield away from the motherboard as much as you can without bending it.

  • Repeat this procedure at different points around the shield until it is free. Remove the shield.

  • Try not to deform the shield too much—you will need to reinstall it during reassembly.

microSD-Kartenleser abtrennen

Setze eine der Spitzen einer abgewinkelten Pinzette in den Spalt an der Ecke der EMI-Abschirmung über dem Stecker des microSD-Kartenlesers ein.

Heble die Abdeckung soweit wie möglich von der Hauptplatine weg, ohne sie zu verbiegen. Entferne sie noch nicht.

Wiederhole das an verschiedenen Stellen um die Abschirmung herum, bis sie sich abgelöst hat. Entferne die Abschirmung.

Verforme die Abschirmung nicht zu stark, du benötigst sie beim Zusammenbau wieder.

[title] Disconnect the microSD card reader
-[* black] Insert one point of a pair of pointed tweezers into a gap in the corner of the EMI shield covering the microSD card reader connector.
+[* black] Insert one point of a pair of [product|IF145-020-2|pointed tweezers] into a gap in the corner of the EMI shield covering the microSD card reader connector.
[* black] Use the tweezers to pry the EMI shield away from the motherboard as much as you can without bending it.
[* black] Repeat this procedure at different points around the shield until it is free. Remove the shield.
[* icon_caution] Try not to deform the shield too much—you will need to reinstall it during reassembly.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0