crwdns2933423:0crwdne2933423:0

Procedura di apertura controller Google Stadia

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:09crwdnd2931529:0crwdne2931529:0

crwdns2936315:0crwdne2936315:0
crwdns2936321:0crwdne2936321:0
crwdns2931653:06crwdne2931653:0
Google Stadia Controller Opening Procedure, Pry open the stadia controller: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Google Stadia Controller Opening Procedure, Pry open the stadia controller: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Google Stadia Controller Opening Procedure, Pry open the stadia controller: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Pry open the stadia controller
  • Insert a Jimmy into the gap between the front and back cover assembly at the inside of the left controller handle.

  • To make sure you insert the Jimmy at the correct position where the clamps are located, you can use this photo.

  • Tilt the Jimmy upwards and push it into the gap between the covers at the same time to pry open the plastic clamp. You should hear a clack noise once the clamp pops open.

  • Once the clamp is completely open, the gap between the two controller covers should be about 2-3 mm wide.

Inserisci un Jimmy nella fessura tra la cover anteriore e quella posteriore nella parte interna dell'impugnatura sinistra del controller.

Per accertarti di inserire il Jimmy nella posizione corretta dove si trovano i morsetti, puoi usare questa foto.

Inclina il Jimmy verso l'alto e spingilo nella fessura tra i case allo stesso momento per aprire il morsetto di plastica. Dovresti sentire un clack quando si apre.

Una volta aperto il morsetto, la fessura tra i case dovrebbe essere larga circa 2-3 mm.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0