crwdns2933423:0crwdne2933423:0

Procedimiento de apertura del controlador Google Stadia

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:09crwdnd2931529:0crwdne2931529:0

crwdns2936315:0crwdne2936315:0
crwdns2936331:0crwdne2936331:0
crwdns2931653:06crwdne2931653:0
Google Stadia Controller Opening Procedure, Pry open the stadia controller: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Google Stadia Controller Opening Procedure, Pry open the stadia controller: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Google Stadia Controller Opening Procedure, Pry open the stadia controller: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Pry open the stadia controller
  • Insert a Jimmy into the gap between the front and back cover assembly at the inside of the left controller handle.

  • To make sure you insert the Jimmy at the correct position where the clamps are located, you can use this photo.

  • Tilt the Jimmy upwards and push it into the gap between the covers at the same time to pry open the plastic clamp. You should hear a clack noise once the clamp pops open.

  • Once the clamp is completely open, the gap between the two controller covers should be about 2-3 mm wide.

Inserta un Jimmy en el hueco entre el ensamblaje de la tapa delantera y trasera en la parte interior del mango del controlador izquierdo.

Para asegurarse de que insertas el Jimmy en la posición correcta donde se encuentran las abrazaderas, puedes utilizar esta foto.

Inclina el Jimmy hacia arriba y empújalo en el hueco entre las cubiertas al mismo tiempo que haces palanca para abrir la abrazadera de plástico. Deberás escuchar un ruido de clack una vez que la abrazadera se abra.

Una vez que la abrazadera está completamente abierta, el espacio entre las dos tapas del controlador debe ser de unos 2-3 mm de ancho.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0