crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

HTC Vive Focus 镜头更换

crwdns2935421:0crwdne2935421:0

crwdns2935425:02crwdne2935425:0

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936311:0crwdne2936311:0
crwdns2931653:02crwdne2931653:0
HTC Vive Focus Lens Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 HTC Vive Focus Lens Replacement: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0

  • Once a lens is removed, install the new one promptly to avoid contamination from any dust or debris in the air.

  • Apply a suction cup to the center of the lens.

  • Pull up on the suction cup to remove the lens from the frame.

  • If the lens does not remove easily, apply a heated iOpener for one minute and try again.

  • The original adhesive can be reused if it was not damaged during disassembly. Place the new lens into the frame and apply a heated iOpener for one minute to bond the new lens to the old adhesive.

  • If the old adhesive was damaged during disassembly, use a spudger to scrape off any remaining adhesive then apply generic adhesive where the old adhesive used to be before installing the new lens.

将吸盘压在镜头上以产生吸力。

拉起吸盘，从镜框上取下镜头。

如果镜片不容易取下，请再次使用加热的 iOpener 一分钟。

原胶在拆卸过程中未损坏可重复使用。将新镜片放入镜框并使用加热的 iOpener 一分钟，将新镜片与旧粘合剂粘合。

如果旧粘合剂在拆卸过程中损坏，请使用撬棒刮掉任何剩余的粘合剂，然后在安装新镜头之前在旧粘合剂所在的位置涂抹通用粘合剂。

-[* black] Apply a suction cup to the lens by pressing down on it to create suction.
+[* icon_caution] Once a lens is removed, install the new one promptly to avoid contamination from any dust or debris in the air.
+[* black] Apply a suction cup to the center of the lens.
[* black] Pull up on the suction cup to remove the lens from the frame.
-[* icon_note] If the lens does not remove easily, apply a heated iOpener again for one minute.
+[* icon_note] If the lens does not remove easily, apply a heated iOpener for one minute and try again.
[* icon_reminder] The original adhesive can be reused if it was not damaged during disassembly. Place the new lens into the frame and apply a heated iOpener for one minute to bond the new lens to the old adhesive.
[* icon_note] If the old adhesive was damaged during disassembly, use a spudger to scrape off any remaining adhesive then apply generic adhesive where the old adhesive used to be before installing the new lens.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0