crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

Reemplazo de lente del HTC Vive Focus

crwdns2935421:0crwdne2935421:0

crwdns2935425:02crwdne2935425:0

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936331:0crwdne2936331:0
crwdns2931653:02crwdne2931653:0
HTC Vive Focus Lens Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 HTC Vive Focus Lens Replacement: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0

  • Once a lens is removed, install the new one promptly to avoid contamination from any dust or debris in the air.

  • Apply a suction cup to the center of the lens.

  • Pull up on the suction cup to remove the lens from the frame.

  • If the lens does not remove easily, apply a heated iOpener for one minute and try again.

  • The original adhesive can be reused if it was not damaged during disassembly. Place the new lens into the frame and apply a heated iOpener for one minute to bond the new lens to the old adhesive.

  • If the old adhesive was damaged during disassembly, use a spudger to scrape off any remaining adhesive then apply generic adhesive where the old adhesive used to be before installing the new lens.

Aplica una ventosa a la lente presionando sobre ella para crear succión.

Tira hacia arriba de la ventosa para retirar la lente de la montura.

Si la lente no se retira fácilmente, aplica de nuevo un iOpener caliente durante un minuto.

El adhesivo original puede reutilizarse si no se ha dañado durante el desmontaje. Coloca la nueva lente en la montura y aplica un iOpener caliente durante un minuto para pegar la nueva lente al adhesivo antiguo.

Si el adhesivo antiguo se ha dañado durante el desmontaje, utiliza un spudger para raspar los restos de adhesivo y aplica un adhesivo genérico en el lugar donde estaba el adhesivo antiguo antes de instalar la nueva lente.

-[* black] Apply a suction cup to the lens by pressing down on it to create suction.
+[* icon_caution] Once a lens is removed, install the new one promptly to avoid contamination from any dust or debris in the air.
+[* black] Apply a suction cup to the center of the lens.
[* black] Pull up on the suction cup to remove the lens from the frame.
-[* icon_note] If the lens does not remove easily, apply a heated iOpener again for one minute.
+[* icon_note] If the lens does not remove easily, apply a heated iOpener for one minute and try again.
[* icon_reminder] The original adhesive can be reused if it was not damaged during disassembly. Place the new lens into the frame and apply a heated iOpener for one minute to bond the new lens to the old adhesive.
[* icon_note] If the old adhesive was damaged during disassembly, use a spudger to scrape off any remaining adhesive then apply generic adhesive where the old adhesive used to be before installing the new lens.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0