crwdns2933423:0crwdne2933423:0

Motorola Moto E6 Plus Vervanging van het dochterbord

crwdns2931527:0crwdnd2931527:0crwdnd2931527:0crwdnd2931527:0crwdne2931527:0

crwdns2936315:0crwdne2936315:0
crwdns2936313:0crwdne2936313:0
crwdns2931653:04crwdne2931653:0
Motorola Moto E6 Plus Daughterboard Replacement, Loosen the adhesive: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 Motorola Moto E6 Plus Daughterboard Replacement, Loosen the adhesive: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
Loosen the adhesive
  • Heat an iOpener and apply it to the bottom edge of the screen for 30 seconds.

  • A hair dryer, heat gun, or hot plate may also be used, but be careful not to overheat the phone—the display and internal battery are both susceptible to heat damage.

  • Apply a few drops of high concentration (over 90%) isopropyl alcohol underneath the vibration motor to loosen the adhesive securing it to the frame.

  • Tilt your phone to allow the isopropyl alcohol to flow underneath the vibration motor.

Verwarm een iOpener en leg deze gedurende 30 seconden op de onderkant van het scherm.

Je kunt hiervoor ook een föhn, warmtepistool of kookplaat voor gebruiken, maar wees bij het gebruik hiervan wel voorzichtig dat je de telefoon niet oververhit. De batterij en het scherm zijn beide erg vatbaar voor warmteschade.

Dien een aantal druppels isopropyl alcohol (>90%) onder de trilmotor toe om de lijm eronder los te maken.

Kantel je telefoon om ervoor te zorgen dat de isopropyl alcohol onder de trilmotor loopt.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0