crwdns2933423:0crwdne2933423:0

Reemplazo de la placa hija del Motorola Moto E6 Plus

crwdns2931527:0crwdnd2931527:0crwdnd2931527:0crwdnd2931527:0crwdne2931527:0

crwdns2936315:0crwdne2936315:0
crwdns2936331:0crwdne2936331:0
crwdns2931653:04crwdne2931653:0
Motorola Moto E6 Plus Daughterboard Replacement, Loosen the adhesive: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 Motorola Moto E6 Plus Daughterboard Replacement, Loosen the adhesive: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
Loosen the adhesive
  • Heat an iOpener and apply it to the bottom edge of the screen for 30 seconds.

  • A hair dryer, heat gun, or hot plate may also be used, but be careful not to overheat the phone—the display and internal battery are both susceptible to heat damage.

  • Apply a few drops of high concentration (over 90%) isopropyl alcohol underneath the vibration motor to loosen the adhesive securing it to the frame.

  • Tilt your phone to allow the isopropyl alcohol to flow underneath the vibration motor.

Calienta un iOpener y aplícalo en el borde inferior de la pantalla durante 30 segundos.

También puedes utilizar un secador de pelo, una pistola de calor o una plancha caliente, pero ten cuidado de no sobrecalentar el teléfono, ya que tanto la pantalla como la batería interna son susceptibles de sufrir daños por el calor.

Aplica unas gotas de alcohol isopropílico de alta concentración (más del 90%) debajo del motor de vibración para aflojar el adhesivo que lo fija al marco.

Inclina el teléfono para que el alcohol isopropílico fluya por debajo del motor de vibración.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0