crwdns2933423:0crwdne2933423:0

Sostituzione batteria Xiaomi Redmi Note 7

crwdns2936315:0crwdne2936315:0
crwdns2936321:0crwdne2936321:0
crwdns2931653:07crwdne2931653:0
Xiaomi Redmi Note 7 Battery Replacement, Remove the pull tabs: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Xiaomi Redmi Note 7 Battery Replacement, Remove the pull tabs: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Xiaomi Redmi Note 7 Battery Replacement, Remove the pull tabs: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Remove the pull tabs
  • Use a pair of blunt nose tweezers to peel the black colored end of the left pull tab off the battery.

  • Grab the pull tab with your tweezers and slowly pull it away from the battery, toward the bottom of the Redmi Note 7.

  • Pull hard enough to maintain tension on the strip, but don't force it. Give it plenty of time to stretch and detach from the battery.

  • Don't press down on the battery. Hold the Redmi Note 7 firmly by its sides.

  • Keep the strip flat and unwrinkled. Try to pull evenly on the whole strip, rather than pulling mainly in the middle or on one side.

  • Pull at a low angle so the strip doesn't snag on the edge of the battery.

  • A good way to get this done is to pull out the adhesive strip about 3 cm and then roll it up on your tweezers.

  • If the adhesive strip breaks off, try to retrieve it using your fingers or blunt tweezers, and continue pulling—but do not pry under the battery.

Usa un paio di pinzette a punta arrotondata per sollevare l'estremità nera della striscia estensibile sinistra della batteria.

Prendi la striscia estensibile con le tue pinzette e tirala lentamente via dalla batteria, verso il bordo inferiore del Redmi Note 7.

Tira con abbastanza forza da mantenere la striscia in tensione, ma non forzarla. Lasciale il tempo per allungarsi e staccarsi dalla batteria.

Non premere sulla batteria. Tieni saldamente il Redmi Note 7 dai suoi bordi.

Tieni la striscia piatta e senza pieghe. Cerca di tirare in egual modo tutta la striscia, piuttosto che tirarla principalmente nel mezzo o da un lato.

Tira la striscia ad un angolo basso in modo che non si impigli nel bordo della batteria.

Un buon modo per fare ciò è tirare la striscia per circa 3 cm e quindi arrotolarla sulle tue pinzette.

Se la striscia adesiva si rompe, cerca di recuperarla usando le dita o delle pinzette a punta arrotondata, e continua a tirare, ma non fare leva sotto la batteria.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0