crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

Loskoppelen van de batterij

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:011crwdnd2931529:0crwdne2931529:0

crwdns2935425:01crwdne2935425:0

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936313:0crwdne2936313:0
crwdns2931653:01crwdne2931653:0
Battery Disconnection, Disconnect the battery: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Battery Disconnection, Disconnect the battery: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Battery Disconnection, Disconnect the battery: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Disconnect the battery

  • Use the flat end of a spudger to pry up and unlatch the metal locking arm on the battery connector.

  • Make sure the metal arm is completely free of the locking tab before lifting the battery connector. The metal locking arm should easily unlatch.

  • Lift straight up on the metal locking arm to pull the battery connector out of its socket on the logic board.

  • During reassembly, press the battery connector straight down into its socket, making sure it sits flush within the socket.

  • If necessary, push the rear, wire side of the connector into place first, then rock the front of the connector into place.

Koppel de batterij los

Gebruik het platte einde van je spudgre om de metalen sluiting op de batterijaansluiting omhoog te duwen.

Zorg dat de metalen sluiting volledig vrij is gekomen van de sluitklem voordat je de batterijaansluiting omhoog tilt. De metalen sluiting zou makkelijk los moeten komen.

Til de metalen sluiting in een rechte beweging omhoog om de batterijaansluiting uit het contact op het logic board te trekken.

Zorg dat je de batterijaansluiting, bij het weer in elkaar zetten van je toestel, recht omlaag het contact in duwt totdat deze volledig op een lijn zit met het contact.

[title] Disconnect the battery
[* black] Use the flat end of a spudger to pry up and unlatch the metal locking arm on the battery connector.
[* icon_caution] Make sure the metal arm is completely free of the locking tab before lifting the battery connector. The metal locking arm should easily unlatch.
[* black] Lift straight up on the metal locking arm to pull the battery connector out of its socket on the logic board.
[* icon_reminder] During reassembly, press the battery connector straight down into its socket, making sure it sits flush within the socket.
+ [* black] If necessary, push the rear, wire side of the connector into place first, then rock the front of the connector into place.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0