crwdns2933423:0crwdne2933423:0

MacBook Air 13" Late 2020 하단 케이스 교체

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:012crwdnd2931529:0crwdne2931529:0

crwdns2935425:01crwdne2935425:0

crwdns2936315:0crwdne2936315:0
crwdns2936325:0crwdne2936325:0
crwdns2931653:01crwdne2931653:0
MacBook Air 13" Late 2020 Lower Case Replacement, Remove the screws securing the lower case: crwdns2935265:00crwdnd2935265:01crwdnd2935265:01crwdne2935265:0
Remove the screws securing the lower case
  • Before starting this procedure, you should disable your Mac's Auto Boot feature. Auto Boot powers on your Mac when you open the lid, and may be accidentally triggered during disassembly. Use this guide to disable Auto Boot.

  • If your MacBook is running Big Sur v11.1 or later, disabling Auto Boot may not work. You can proceed normally, but make sure to disconnect the battery as soon as you're inside.

  • Completely power off and unplug your MacBook before you start. Close the display and flip the entire laptop upside-down.

  • Use a P5 driver to remove the following screws:

  • Two 7.9 mm screws

  • Two 7.3 mm screws

  • Six 2.6 mm screws

  • Throughout this repair, keep track of each screw and make sure it goes back exactly where it came from to avoid damaging your MacBook.

이 절차를 시작하기 전에 Mac Auto Boot/자동 부팅 기능을 비활성화해야 합니다. Auto Boot/자동 부팅은 덮개를 열면 Mac 전원을 켜며 분해 도중 실수로 촉발할 수 있습니다. 이 안내서를 사용하여 Auto Boot/자동 부팅을 비활성화 하세요.

MacBook이 Big Sur v11.1 이상을 사용하는 경우, 자동 부팅을 비활성화 하지 못할 수도 있습니다. 절차를 정상적으로 진행하세요, 하지만 내부로 진입하는 즉시 배터리를 분리하세요.

시작하기 전에 MacBook Air 전원을 완전히 끄고 플러그를 뽑으세요. 디스플레이를 닫고 노트북 전체를 뒤집으세요.

P5 드라이버를 사용하여 다음 나사들을 풀어주세요:

7.9mm 나사 두 개

7.3mm 나사 두 개

2.6mm 나사 여섯 개

수리하는 동안, 각 나사를 추적하여 MacBook을 손상하지 않도록 원래 위치로 정확히 돌아가는 것을 확인하세요.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0