crwdns2935425:02crwdne2935425:0
crwdns2931653:02crwdne2931653:0
-
Using fine tip tweezers, disconnect the four electrical connectors on the board surface.
-
Using a Phillips #00 screwdriver, remove the two 5mm screws on either side of the motor.
-
Lift the motor from the board and set it to the side.
-
Using a Phillips #00 screwdriver, remove the 6mm screw from the antenna housing.
crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0