Toniebox Broken Ear Repair

crwdns2936071:01crwdne2936071:0 — Remove the defective button

Remove the ears from the Toniebox according to the basic instructions for the Toniebox Teardown. Be especially careful not to damage the connector on the PCB.

crwdns2936071:02crwdne2936071:0 — Desoldering the defective button

Solder the defective button from the PCB. The best way to do this is to use a hot air gun/ soldering iron around 360 ° C

crwdns2936071:03crwdne2936071:0 — Solder the new button

Use lead free solder to reattach the replacement button

crwdns2936071:04crwdne2936071:0 — Soldering the torn cable

Remove the remains of the torn strand from the solder pads with the soldering iron

crwdns2936071:05crwdne2936071:0 — Installation of repaired button

Carefully put the circuit board back into the ear.