crwdns2933423:0crwdne2933423:0

Reemplazo del cristal trasero del Huawei P40 Pro

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:04crwdnd2931529:0crwdne2931529:0

crwdns2936315:0crwdne2936315:0
crwdns2936331:0crwdne2936331:0
crwdns2931653:02crwdne2931653:0
Huawei P40 Pro Rear Glass Replacement, Insert an opening wheel: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Huawei P40 Pro Rear Glass Replacement, Insert an opening wheel: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Huawei P40 Pro Rear Glass Replacement, Insert an opening wheel: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Insert an opening wheel
  • Since the rear glass of the Huawei P40 Pro is curved, we highly recommend to slice the adhesive with a softer plastic tool like the iMac opening wheel before working with opening picks to prevent the rear glass from shattering.

  • Secure a suction handle to the bottom edge of the rear glass, as close to the curved edge as possible.

  • If your rear glass is badly cracked, covering it with a layer of clear packing tape may allow the suction cup to adhere. Alternatively, very strong tape may be used instead of the suction cup. If all else fails, you can superglue the suction cup to the rear glass.

  • Lift the back cover with the suction handle to create a small gap between the back cover and the frame.

  • In case you have trouble creating a gap, apply more heat to further soften the adhesive. Follow the iOpener instructions to avoid overheating.

  • Insert an iMac opening wheel into the gap.

  • Slide the opening wheel to the bottom left corner to slice the adhesive.

Ya que el cristal trasero del Huawei P40 Pro es curvo, recomendamos encarecidamente cortar el adhesivo con una herramienta de plástico más blanda como la rueda de apertura del iMac antes de trabajar con púas de apertura para evitar que el cristal trasero se rompa.

Fija una ventosa en el borde inferior del cristal trasero, lo más cerca posible del borde curvo.

Si el cristal trasero está muy agrietado, cubrirlo con una capa de cinta de embalar transparente puede permitir que la ventosa se adhiera. También se puede utilizar cinta adhesiva muy resistente en lugar de la ventosa. Si todo lo demás falla, puede pegar la ventosa al cristal trasero.

Levanta la tapa trasera con la ventosa para crear un pequeño hueco entre la tapa trasera y el marco.

Si tienes problemas para crear un hueco, aplica más calor para ablandar más el adhesivo. Sigue las instrucciones de iOpener para evitar el sobrecalentamiento.

Inserta una rueda de apertura del iMac en el hueco.

Desliza la rueda de apertura hacia la esquina inferior izquierda para cortar el adhesivo.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0