crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

Oculus Quest 2 拆解

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936311:0crwdne2936311:0
crwdns2931653:02crwdne2931653:0
Oculus Quest 2 Disassembly, Remove the rear cover: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 Oculus Quest 2 Disassembly, Remove the rear cover: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
Remove the rear cover

  • One side at a time, insert a pick next to the nosepiece, slide it to the edge and pry.

  • When both sides are loose, carefully lift the cover out, and fold it so that the nose piece is on the outer perimeter of the device, as shown in the second image.

  • The proximity sensor is still connected via a flex cable, so be careful to not rip or crease the cable.

  • Lift the small black clip on the ZIF connecter up, and pull the flex cable out.

  • The cable is lightly adhered to the headset so be careful when removing it.

  • During reassembly, make sure to position the cable correctly. Latching the small black clip back on shouldn't require much force. If you don't connect the cable correctly, the headset's screen may stay black and the device will turn off after a few seconds.

卸下后盖

一次拆卸一侧，在鼻架旁插入一个撬片，将其滑到外侧边缘并撬起。

当两边都松动时，小心地将后盖提起并取出，并折叠它，使鼻托位于设备的外周，如第二张图片所示。

接近传感器仍通过排线连接在后盖上，因此请注意不要扯坏排线。

向上提起 ZIF 连接器上的黑色小夹子，然后将排线拉出。

排线轻轻地粘在设备上，因此取下它时要小心。

在重新组装过程中，请确保正确放置排线。将小黑色小扣子重新锁上不需要太大的力。如果未正确连接线缆，设备的屏幕可能不会亮起，并且设备会在几秒钟后关闭。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0