crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

Sustituir las piezas rotas del conector

crwdns2935421:0crwdne2935421:0

crwdns2935425:04crwdne2935425:0

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936331:0crwdne2936331:0
crwdns2931653:04crwdne2931653:0
Remove Dislodged Plug Parts, Remove Plug Circuit Board: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 Remove Dislodged Plug Parts, Remove Plug Circuit Board: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
Remove Plug Circuit Board

  • Remove the two small, shorter philips screws securing the board to the body

  • The board is now held in by vinyl tape (black) and two ribbon cables

  • If you are just removing broken plug pieces, do not disconnect these ribbon cables - be careful not to damage them! Instead, simply lift the board enough to poke tweezers or similar through the plug to dislodge broken bits

  • If replacing the plug, disconnect the ribbon cables (one is soldered in place) from the circuit board and replace the board

Retira la placa de circuito del enchufe

Retira los dos tornillos Philips pequeños y más cortos que sujetan la placa al cuerpo.

El tablero ahora está sujeto por cinta de vinilo (negra) y dos cables planos.

Si solo estás quitando piezas de enchufe rotas, no desconectes estos cables de cinta, ¡ten cuidado de no dañarlos! En su lugar, simplemente levanta la placa lo suficiente como para introducir pinzas o algo similar a través del tapón para desalojar las piezas rotas.

Si reemplazas el enchufe, desconecta los cables planos (uno está soldado en su lugar) de la placa de circuito y reemplaza la placa

[title] Remove Plug Circuit Board
[* black] Remove the two small, shorter philips screws securing the board to the body
[* black] The board is now held in by vinyl tape (black) and two ribbon cables
-[* black] If you are just removing broken plug pieces, ***do not disconnect*** these ribbon cables - ***be careful*** not to damage them! ''Instead, simply lift the board enough to poke tweezers or similar through the plug to dislodge broken bits''
+[* black] If you are just removing broken plug pieces, ***do not disconnect*** these ribbon cables - ***be careful*** not to damage them! ''Instead, simply lift the board enough to poke [product|IF145-020|tweezers] or similar through the plug to dislodge broken bits''
[* black] If replacing the plug, disconnect the ribbon cables (one is soldered in place) from the circuit board and replace the board

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0