Google Pixel 4a 屏幕置换

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:011crwdnd2931529:0crwdne2931529:0

crwdns2935425:015crwdne2935425:0

crwdns2936315:0crwdne2936315:0

crwdns2936311:0crwdne2936311:0

crwdns2931653:015crwdne2931653:0

Remove the screen

Remove the screen.
To install a new screen:
Check if your replacement screen has speaker mesh and top edge adhesive pre-installed.
If it does, you won't need the top edge adhesive.
If it doesn't, remove the larger clear liner from the top edge adhesive and apply it to the screen (not the frame). Make sure the larger cutout lines up with the speaker mesh.
Follow this guide to apply the custom-cut adhesive.
Use the third photo as a reference to position your adhesives.
During the boot-up process after reassembly, the screen will go through a calibration sequence. Don't touch the screen during this process, as it could result in improper touch calibration and create touch issues.

移除屏幕

拆掉屏幕
把新屏幕和原装的比较一下，有些零件你需要从原装屏上卸下并装到新屏幕上（如喇叭的金属网）。
安装新的屏幕
从手机的边框上清除剩余粘胶。
请遵循指南来粘胶。
请遵循指南来使用双面粘胶。

	[title] Remove the screen
	[* black] Remove the screen.
-	[* black] Compare your replacement screen with the original. You may need to transfer additional components (such as speaker mesh) to the new part.
-	[* icon_reminder] To install the new screen:
-	[* black] Scrape off remaining adhesive from the perimeter of the frame.
-	[* black] [guide\|126585\|Follow this guide\|new_window=true] if you are using custom-cut adhesives.
-	[* black] If you are using double-sided tape such as Tesa tape, [guide\|113604\|follow this guide\|new_window=true].
+	[* icon_reminder] To install a new screen:
+	[* red] Check if your replacement screen has speaker mesh and top edge adhesive pre-installed.
+	[* black] If it does, you won't need the [link\|https://guide-images.cdn.ifixit.com/igi/URl4UmAoxJKgCBvy.full\|top edge adhesive\|new_window=true].
+	[* black] If it doesn't, remove the larger clear liner from the [link\|https://guide-images.cdn.ifixit.com/igi/URl4UmAoxJKgCBvy.full\|top edge adhesive\|new_window=true] and apply it to the *''screen''* (not the frame). Make sure the larger cutout lines up with the speaker mesh.
+	[* black] Follow [guide\|126585\|this guide\|new_window=true] to apply the custom-cut adhesive.
+	[* icon_note] Use the third photo as a reference to position your adhesives.
+	[* icon_caution] During the boot-up process after reassembly, the screen will go through a calibration sequence. Don't touch the screen during this process, as it could result in improper touch calibration and create touch issues.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0