BaByliss Titanium T83a Battery Replacement

crwdns2936071:01crwdne2936071:0 — Loosen housing screw at rear-bottom

Remove the screw at the bottom of the housing with a Phillips-head screwdriver.

crwdns2936071:02crwdne2936071:0 — Loosen rear upper housing screw

The upper housing screws are covered by the size adjustment. This must first be set to high via the adjustment wheel on the front.

crwdns2936071:03crwdne2936071:0 — Loosen circuit board and setting wheel

Remove the upper housing cover. The one below cannot be removed yet. The frame for the attachments must be removed first. This can be done more easily by loosening the adjusting wheel and the small circuit board.

crwdns2936071:04crwdne2936071:0 — Loosen the adjusting wheel from the attachment frame

The adjusting wheel is connected to the frame of the cutting attachments. This can be loosened with the fingers without tools when the wheel is removed.

crwdns2936071:05crwdne2936071:0 — Intermediary step

The picture also shows once again the connection between the attachment frame and the setting wheel.

crwdns2936071:06crwdne2936071:0

Loosen the screws of the motor

crwdns2936071:07crwdne2936071:0

The batteries can now be soldered to the board.