crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

Changement coque arrière OnePlus Nord

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:03crwdnd2931529:0crwdne2931529:0

crwdns2935423:0crwdne2935423:0

crwdns2935425:01crwdne2935425:0

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936317:0crwdne2936317:0
crwdns2931653:01crwdne2931653:0
OnePlus Nord Rear Glass Replacement, Loosen the rear glass adhesive: crwdns2935265:00crwdnd2935265:01crwdnd2935265:01crwdne2935265:0
Loosen the rear glass adhesive

  • Switch off your phone.

  • Heat an iOpener to loosen the adhesive beneath the rear glass. Apply the iOpener for at least two minutes. If you have a heatbed with precise temperature control (like any FDM 3D printer with heatbed) 45°C is enough. You might want to repeat this step several times during the rear glass removal.

  • A hair dryer, heat gun, or hot plate may also be used, but be careful not to overheat the phone—the AMOLED display and internal battery are both susceptible to heat damage.

Ramollir l'adhésif de la coque arrière

Éteignez votre téléphone.

Faites chauffer un iOpener pour ramollir l'adhésif de la coque arrière. Laissez l'iOpener agir au moins 2 minutes. Vous aurez peut-être besoin de répéter l'opération plusieurs fois pendant le retrait de la coque.

Un sèche-cheveux, un pistolet à air chaud ou une plaque chauffante peuvent également être utilisés, mais attention à ne pas surchauffer le téléphone - l'écran AMOLED et la batterie sont vulnérables à la chaleur.

[title] Loosen the rear glass adhesive
[* black] Switch off your phone.
-[* black] [guide|25705|Heat an iOpener|new_window=true] to loosen the adhesive beneath the rear glass. Apply the iOpener for at least two minutes. You might want to repeat this step several times during the rear glass removal.
+[* black] [guide|25705|Heat an iOpener|new_window=true] to loosen the adhesive beneath the rear glass. Apply the iOpener for at least two minutes. If you have a heatbed with precise temperature control (like any FDM 3D printer with heatbed) 45°C is enough. You might want to repeat this step several times during the rear glass removal.
[* icon_note] A hair dryer, heat gun, or hot plate may also be used, but be careful not to overheat the phone—the AMOLED display and internal battery are both susceptible to heat damage.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0