crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

Reemplazo del cristal trasero del OnePlus Nord

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:03crwdnd2931529:0crwdne2931529:0

crwdns2935423:0crwdne2935423:0

crwdns2935425:01crwdne2935425:0

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936331:0crwdne2936331:0
crwdns2931653:01crwdne2931653:0
OnePlus Nord Rear Glass Replacement, Loosen the rear glass adhesive: crwdns2935265:00crwdnd2935265:01crwdnd2935265:01crwdne2935265:0
Loosen the rear glass adhesive

  • Switch off your phone.

  • Heat an iOpener to loosen the adhesive beneath the rear glass. Apply the iOpener for at least two minutes. If you have a heatbed with precise temperature control (like any FDM 3D printer with heatbed) 45°C is enough. You might want to repeat this step several times during the rear glass removal.

  • A hair dryer, heat gun, or hot plate may also be used, but be careful not to overheat the phone—the AMOLED display and internal battery are both susceptible to heat damage.

Ablanda el adhesivo de cristal trasero

Apaga el teléfono.

Caliente un iOpener para aflojar el adhesivo debajo del vidrio trasero. Aplica el iOpener durante al menos dos minutos. Es posible que desee repetir este paso varias veces durante la extracción de vidrio trasero.

También se puede usar un secador de pelo, una pistola de calor o una placa caliente, pero tenga cuidado de no sobrecalentar el teléfono: la pantalla AMOLED y la batería son susceptibles a daños por calor.

[title] Loosen the rear glass adhesive
[* black] Switch off your phone.
-[* black] [guide|25705|Heat an iOpener|new_window=true] to loosen the adhesive beneath the rear glass. Apply the iOpener for at least two minutes. You might want to repeat this step several times during the rear glass removal.
+[* black] [guide|25705|Heat an iOpener|new_window=true] to loosen the adhesive beneath the rear glass. Apply the iOpener for at least two minutes. If you have a heatbed with precise temperature control (like any FDM 3D printer with heatbed) 45°C is enough. You might want to repeat this step several times during the rear glass removal.
[* icon_note] A hair dryer, heat gun, or hot plate may also be used, but be careful not to overheat the phone—the AMOLED display and internal battery are both susceptible to heat damage.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0