DDX/ Copperhead Hotend Installation

crwdns2935421:0crwdne2935421:0 crwdns2935423:0crwdne2935423:0

crwdns2935425:04crwdne2935425:0

crwdns2935419:0crwdne2935419:0

crwdns2936315:0crwdne2936315:0

crwdns2936321:0crwdne2936321:0

crwdns2931653:04crwdne2931653:0

DDX/ Copperhead Hotend Installation, Cut PTFE Tube To Spec: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0

DDX/ Copperhead Hotend Installation, Cut PTFE Tube To Spec: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0

DDX/ Copperhead Hotend Installation, Cut PTFE Tube To Spec: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0

Cut PTFE Tube To Spec

Insert the Capricorn tube in the cutting fixture
Drive it until it fits the Adapter
Pressing all together use the hobby knife to cut the tube straight.
At the end, the Capricorn should stand out about 5mm.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0