Raptor X Axis Linear Rail Install

crwdns2935421:0crwdne2935421:0 crwdns2935423:0crwdne2935423:0

crwdns2935425:02crwdne2935425:0

crwdns2935419:0crwdne2935419:0

crwdns2936315:0crwdne2936315:0

crwdns2936323:0crwdne2936323:0

crwdns2931653:02crwdne2931653:0

Raptor X Axis Linear Rail Install, Disassembly 1b.: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0

Raptor X Axis Linear Rail Install, Disassembly 1b.: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0

Raptor X Axis Linear Rail Install, Disassembly 1b.: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0

Disassembly 1b.

The X Axis assembly is attached to the X/Z trolleys with 4 M4 cap screws and T nuts.
Unplug the X End Stop then the X Motor (this can be done before or after X Axis removal depending on your access)
Remove the assembly by loosening the cap screws from the back of the machine. The T nuts just need to align parallel to the slot.
Hold on to the X Axis assembly with one hand. If not, it will fall onto the bed.
Be sure the X Motor is unplugged

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0