crwdns2935425:04crwdne2935425:0
crwdns2931653:04crwdne2931653:0
Clean SMT Buttons
-
You need clean any residual solder and flux from buttons you harvested from your parts only board. Use solder wick to clean all the J leads on the button.
-
Warning: you can damage the casing and leads on the button if you remove it incorrectly or apply to much heat.
-
Tip: tip check the operation of the button to be sure it wasn't damaged in the removal process.
-
Tip: make sure you clean any excess flux from the button.
crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0