Check the Jura ENA micro 9 brew assembly

crwdns2936071:01crwdne2936071:0

The drive is on the left, the pulp shovel can be seen on the right.

crwdns2936071:02crwdne2936071:0

Disengage the brown pulp shovel at the top.

crwdns2936071:03crwdne2936071:0

Remove the two Torx T20 machine screws that secure the drive to the upper piston.

crwdns2936071:04crwdne2936071:0

In this step the two side covers are removed. They are each locked in four places, some of which are hidden.

crwdns2936071:05crwdne2936071:0

In this step, the two guide plates on the left and right are removed

crwdns2936071:06crwdne2936071:0

Slide the drainage valve down and out.

crwdns2936071:07crwdne2936071:0

Here you can see the current status

crwdns2936071:08crwdne2936071:0

In the following step the lower piston is released.

crwdns2936071:09crwdne2936071:0

Unscrew the Phillips screw in the sieve of the lower piston and disassemble the piston.

crwdns2936071:010crwdne2936071:0

Unscrew the Phillips screw on the sieve of the upper piston and lift the sieve off.

crwdns2936071:011crwdne2936071:0

The brew assembly is now dismantled. Now you have to clean all parts thoroughly, replace the seals on the upper and lower pistons, and thinly grease them and the cylinder wall with food-safe silicone. Now the drainage valve should also be revised.