crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:014crwdnd2931529:0crwdne2931529:0
crwdns2935425:07crwdne2935425:0
crwdns2931653:07crwdne2931653:0
-
Insert an opening pick into the lower-left corner of the rear panel.
-
Using another opening pick, cut the adhesive along the left edge of the rear panel.
| + | [* icon_caution] Be careful near the corners, as the glass is weakest there. |
|---|---|
| [* black] Insert an opening pick into the lower-left corner of the rear panel. | |
| [* black] Using another opening pick, cut the adhesive along the left edge of the rear panel. | |
| - | [* icon_caution] |
| + | [* icon_caution] Don't insert an opening pick in more than halfway on the left edge near the fingerprint sensor or you may damage the ribbon cable inside. |
| [* icon_note] It is fine if opening picks fall out as the back cover becomes separated. |
crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0