crwdns2933423:0crwdne2933423:0

후면 커버 분리

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:014crwdnd2931529:0crwdne2931529:0

crwdns2936315:0crwdne2936315:0
crwdns2936325:0crwdne2936325:0
crwdns2931653:07crwdne2931653:0
Back Cover Removal: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Back Cover Removal: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Back Cover Removal: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
  • Be careful near the corners, as the glass is weakest there.

  • Insert an opening pick into the lower-left corner of the rear panel.

  • Using another opening pick, cut the adhesive along the left edge of the rear panel.

  • Don't insert an opening pick in more than halfway on the left edge near the fingerprint sensor or you may damage the ribbon cable inside.

  • It is fine if opening picks fall out as the back cover becomes separated.

후면 패널 왼편-하단 모서리에 여는 픽을 끼우세요.

다른 여는 픽을 사용하여 후면 패널의 왼편 가장자리를 따라 접착제를 자르세요.

지문 센서 근처 왼편 가장자리에 픽을 절반 이상 끼우지 마세요. 아니면 내부 리본 케이블을 손상할 수 있습니다.

후면 커버가 분리될 때 여는 픽은 빠져도 괜찮습니다.

+[* icon_caution] Be careful near the corners, as the glass is weakest there.
[* black] Insert an opening pick into the lower-left corner of the rear panel.
[* black] Using another opening pick, cut the adhesive along the left edge of the rear panel.
-[* icon_caution] Do not insert an opening pick in more than half way on the left edge near the fingerprint sensor or you may damage the ribbon cable inside.
+[* icon_caution] Don't insert an opening pick in more than halfway on the left edge near the fingerprint sensor or you may damage the ribbon cable inside.
[* icon_note] It is fine if opening picks fall out as the back cover becomes separated.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0