crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

バックカバーの取り外し

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:014crwdnd2931529:0crwdne2931529:0

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936323:0crwdne2936323:0
crwdns2931653:07crwdne2931653:0
Back Cover Removal: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Back Cover Removal: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Back Cover Removal: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0

  • Be careful near the corners, as the glass is weakest there.

  • Insert an opening pick into the lower-left corner of the rear panel.

  • Using another opening pick, cut the adhesive along the left edge of the rear panel.

  • Don't insert an opening pick in more than halfway on the left edge near the fingerprint sensor or you may damage the ribbon cable inside.

  • It is fine if opening picks fall out as the back cover becomes separated.

オープニングピックを背面パネルの左下隅に差し込みます。

別のオープニングピックを使って、背面パネルの左端に沿って粘着剤を切ります。

指紋センサー付近の左端に半分以上オープニングピックを差し込むと、内部のリボンケーブルが破損することがあります。

背面カバーが分離する際に、オープニングピックが落ちてもかまいません。

+[* icon_caution] Be careful near the corners, as the glass is weakest there.
[* black] Insert an opening pick into the lower-left corner of the rear panel.
[* black] Using another opening pick, cut the adhesive along the left edge of the rear panel.
-[* icon_caution] Do not insert an opening pick in more than half way on the left edge near the fingerprint sensor or you may damage the ribbon cable inside.
+[* icon_caution] Don't insert an opening pick in more than halfway on the left edge near the fingerprint sensor or you may damage the ribbon cable inside.
[* icon_note] It is fine if opening picks fall out as the back cover becomes separated.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0