crwdns2933423:0crwdne2933423:0

DeLonghi ETAM series control panel removal

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:02crwdnd2931529:0crwdne2931529:0

crwdns2935425:02crwdne2935425:0

crwdns2936319:0crwdne2936319:0
crwdns2936315:0crwdne2936315:0
crwdns2931653:02crwdne2931653:0
DeLonghi ETAM Serie Bedienpanel abnehmen: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 DeLonghi ETAM Serie Bedienpanel abnehmen: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
  • Hebe das Bedienpanel ein wenig hoch. Drücke die Verriegelung am weißen Stecker und ziehe den Stecker ab.

  • Fädle das Flachbandkabel, das nach hinten zur Steuerelektronik führt, soweit wie möglich aus. Dadurch wird es länger und du kannst das Bedienpanel an der Seite abstellen.

  • Wenn du das Bedienpanel ganz ausbauen willst, musst du den Deckel an der Steuerelektronik abnehmen und den Stecker abtrennen. Dann kannst du das Kabel ganz ausfädeln.

Lift up the control panel a little. Press the latch on the white plug and pull off the plug.

Unthread the ribbon cable that leads to the control electronics at the back as far as possible. This will make it longer and you can place the control panel on its side.

If you want to remove the control panel completely, you have to take off the cover on the control electronics and disconnect the connector. Then you can unthread the cable completely.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0