Samsung Galaxy A51 Screen Replacement

crwdns2933809:0crwdne2933809:0

crwdns2935433:0crwdne2935433:0

Samsung Galaxy A51 SIM Tray Removal

Samsung Galaxy A51 Back Cover Replacement

Samsung Galaxy A51 Midframe Replacement

Battery Disconnect

crwdns2935443:0crwdne2935443:0

= crwdns2915112:0crwdne2915112:0 = crwdns2861241:0crwdne2861241:0

crwdns2936315:0crwdne2936315:0

crwdns2936129:0crwdne2936129:0

crwdns2947189:0crwdne2947189:0

crwdns2915892:0crwdne2915892:0

Use this guide to replace a cracked or broken screen on your Samsung Galaxy A51.[br]
[br]
'''Note:''' The function of the fingerprint sensor might be lost after this screen replacement. Security patches installed after September 2020 don’t support this repair. [br]
[br]
If the frame is deformed, it's important to replace it to make sure the new screen will mount correctly and won’t suffer damage from uneven pressure. [br]
[br]
Before disassembling your phone, discharge the battery below 25%. The battery can catch fire and/or explode if accidentally punctured, but the chances of that happening are much lower if discharged.[br]
[br]
This guide instructs you to replace the screen while leaving the original frame and motherboard in place. However, some replacement screens for this phone come pre-installed in a new frame (a.k.a. chassis), which requires a very different procedure. Make sure you have the correct part before starting this guide.[br]
[br]
You’ll need replacement adhesive to reattach components when reassembling the device.

crwdns2915888:0crwdne2915888:0

crwdns2936129:0crwdne2936129:0

crwdns2947189:0crwdne2947189:0

crwdns2915892:0crwdne2915892:0

crwdns2915888:0crwdne2915888:0

crwdns2931349:0crwdne2931349:0

crwdns2936071:01crwdne2936071:0

Use the flat end of a spudger to pry up and disconnect the display flex cable on the bottom of the phone.

crwdns2936071:02crwdne2936071:0

Prepare an iOpener and apply it to the display for at least two minutes to loosen the adhesive beneath.

crwdns2936071:03crwdne2936071:0

Once the screen is warm to the touch, apply a suction cup to the upper edge of the phone.

crwdns2936071:04crwdne2936071:0

Insert a second opening pick and slide it to the top left corner.

crwdns2936071:05crwdne2936071:0

Insert a third opening pick and slide it along the left edge to cut the adhesive.

crwdns2936071:06crwdne2936071:0

Insert a fourth opening pick and slide it from the bottom left corner to the bottom right corner.

crwdns2936071:07crwdne2936071:0

Insert a fifth opening pick and slide it along the left edge of the phone to cut the remaining adhesive.

crwdns2936071:08crwdne2936071:0

Reapply a heated iOpener to the screen to loosen the adhesive underneath.

crwdns2936071:09crwdne2936071:0

Insert a plastic card on the left edge into the gap between display and the phone assembly.

crwdns2936071:010crwdne2936071:0

Carefully thread the display cable through the frame.

crwdns2936071:011crwdne2936071:0

Remove the screen.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0