crwdns2935425:08crwdne2935425:0
crwdns2931653:08crwdne2931653:0
Final assembly
-
Insert the PCB so that the CO2 sensor is on the side of the Sigrow logo.
-
The PCB should be pressed against the PCB plate.
-
The antenna should now stick out less than 5 mm.
-
Slide the hat over the case. The hat should fit well and not come lose if you shake the senor hard.
crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0