crwdns2933423:0crwdne2933423:0

MacBook Air 13インチ Retina Display 2019 下部ケースの交換

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:027crwdnd2931529:0crwdne2931529:0

crwdns2935425:01crwdne2935425:0

crwdns2936315:0crwdne2936315:0
crwdns2936323:0crwdne2936323:0
crwdns2931653:01crwdne2931653:0
MacBook Air 13" Retina Display 2019 Lower Case Replacement, Remove the screws securing the lower case: crwdns2935265:00crwdnd2935265:01crwdnd2935265:01crwdne2935265:0
Remove the screws securing the lower case
  • Before starting this procedure, you should disable your Mac's Auto Boot feature. Auto Boot powers on your Mac when you open the lid, and may be accidentally triggered during disassembly. Use this guide to disable Auto Boot.

  • If your MacBook is running Big Sur v11.1 or later, disabling Auto Boot may not work. You can proceed normally, but make sure to disconnect the battery as soon as you're inside.

  • Completely power off and unplug your MacBook Air before you start. Close the display and flip the entire laptop upside-down.

  • Use a P5 driver to remove the following screws:

  • Two 7.9 mm screws

  • Two 7.1 mm screws

  • Six 2.6 mm screws

この手順を始める前に、Macのオートブート機能を解除する必要があります。 自動起動中、蓋を開けるとMacの電源をオンにし、分解中に誤ってトリガーされる可能性があります。 こちらのガイドを参照して自動起動を無効にします。

MacBookにBig Sur v11.1以降がインストールされている場合、自動起動を無効にするとうまくいかないことがあります。通常通りに作業を進めることができますが、開口できたらすぐにバッテリーを外してください。

作業を始める前に、MacBook Airの電源を切り、プラグから外します。ディスプレイを閉じて、ラップトップ全体を裏返します。

P5ドライバーを使って、次のネジを外します。

7.9mmネジー2本

7.1mmネジー2本

2.6mmネジー6本

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0