Dexter Corded Belt Sander - 900BS2.5 Motor Replacement

crwdns2936071:01crwdne2936071:0 — Unplug

Before you begin, remember to disconnect the mains plug.

crwdns2936071:02crwdne2936071:0

Remove the handle, by unscrewing the screw.

crwdns2936071:03crwdne2936071:0

Pry the tape off.

crwdns2936071:04crwdne2936071:0

Unscrew the 4 screws.

crwdns2936071:05crwdne2936071:0

Remove the belt, then unscrew the screws of the shell to gain access to the motor.

crwdns2936071:06crwdne2936071:0

Remove both accessories.

crwdns2936071:07crwdne2936071:0

Remove the screws from the hull in order to have access to the interior and allow the carbon brushes to be blocked.

crwdns2936071:08crwdne2936071:0

Relax the small metal strip to be able to separate the carbons.

crwdns2936071:09crwdne2936071:0

Replace the new part in its housing.

crwdns2936071:010crwdne2936071:0

Open the cap of the new part to replace the belt.

crwdns2936071:011crwdne2936071:0

Tighten the four screws.

crwdns2936071:012crwdne2936071:0

Replace the tip, band and handle.