crwdns2933423:0crwdne2933423:0

MacBook Pro 13" Unibody Mid 2009光学ドライブの交換

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:04crwdnd2931529:0crwdne2931529:0

crwdns2936315:0crwdne2936315:0
crwdns2936323:0crwdne2936323:0
crwdns2931653:02crwdne2931653:0
MacBook Pro 13" Unibody Mid 2009 Optical Drive Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:01crwdne2935265:0
  • It will be necessary to slide the small clear plastic cable retainer (boxed in red) glued to the logic board out of the way before disconnecting the camera cable. Be careful not to break any components off the board as you slide it away from the camera cable connector.

  • Pull the camera cable connector toward the optical drive to disconnect it from the logic board.

  • This socket is metal and easily bent. Be sure to align the connector with its socket on the logic board before mating the two pieces.

カメラケーブルの接続を外す前に、基板に接着剤で留められた小さな透明のプラスチックのケーブルリテイナー(赤く囲まれた箇所)をスライドしてください。基板から外す際にカメラケーブルコネクタからリテイナーをスライドするため、他のコンポーネントにダメージを与えないようご注意ください。

カメラケーブルコネクタを光学ドライブ側に向けて引っ張り、基板から接続を外します。

このソケットはメタル製で簡単に曲がってしまいます。コネクタを基板上のソケットに取り付ける前に、装着位置が揃っているか確認してください。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0