crwdns2933423:0crwdne2933423:0

Anycubic Predator BTT SKR 1.4 Motherboard Replacement

crwdns2936315:0crwdne2936315:0
crwdns2936321:0crwdne2936321:0
crwdns2931653:04crwdne2931653:0
Anycubic Predator BTT SKR 1.4 Motherboard Replacement, Install steppers onto SKR: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 Anycubic Predator BTT SKR 1.4 Motherboard Replacement, Install steppers onto SKR: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
Install steppers onto SKR
  • There's many options for stepper motor drivers. I've installed TMC2209s that were purchased with the board.

  • Make sure you print a support to hold the new motherboard. I haven't yet found a mount that takes the standoffs into account, but there are many options.

  • If you are installing the TMC2208/2209 drivers, then remove all the black jumpers located under the stepper driver sockets EXCEPT the one indicated in the diagram.

  • The pictured mount is: https://www.thingiverse.com/thing:431169...

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0