Position the front enclosure face down on a protective surface so that it is upside down and to the left of the rear enclosure assembly.

Plug in LCD connector/ cable into the connector located through the LCD shield.

Install the U-shaped aluminum bracket oriented foam side down onto the studs protruding from the LCD shield.

Thread the (2) 4mm lock nuts onto the studs. While pressing down on the center of the bracket, tighten both lock nuts.

Attach the green LCD ground wire to the corner of the LCD shield with the (1) 3mm x 14mm Phillips head screw and lock washer.

Position the front enclosure standing up so that it is approximately 4 inches from the rear enclosure.

Connect the inverter cable to the top of the electronic module.

Connect the ribbon cable (from the bottom of the electronic module) to the interface PC board located in the middle of the front enclosure. Verify that the connector's side retaining clips are snapped into place.