crwdns2933423:0crwdne2933423:0

Sostituzione del cavo danneggiato

crwdns2936315:0crwdne2936315:0
crwdns2936321:0crwdne2936321:0
crwdns2931653:07crwdne2931653:0
Damaged Wire Replacement, Use Heatgun: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 Damaged Wire Replacement, Use Heatgun: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
Use Heatgun
  • Slide the heat shrink tubing over the exposed wires.

  • Using the heat gun, slowly go back and forth over the shrink wrap, allowing for even heat distribution and the wrap to close.

  • Depending on the heat gun setting, shrink wraps should take anywhere from 10-25 seconds to fully constrict around the wire.

  • Heat guns take little time to heat up and much longer to cool down. Use caution when setting this tool down and make sure it's cool when picking it up after use.

Fai scorrere la guaina termorestringente sui fili esposti.

Usando la pistola termica, vai lentamente avanti e indietro sulla pellicola termoretraibile, consentendo una distribuzione uniforme del calore e la chiusura dell'involucro.

A seconda dell'impostazione della pistola termica, le fasce termoretraibili dovrebbero impiegare dai 10 ai 25 secondi per restringersi completamente attorno al cavo.

Le pistole termiche impiegano poco tempo per riscaldarsi e molto più tempo per raffreddarsi. Fai attenzione quando riponi questo strumento e assicurati che sia freddo quando lo prendi in mano dopo l'uso.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0